You are currently viewing How To Apply Concrete Sealer With A Pump Sprayer

How To Apply Concrete Sealer With A Pump Sprayer

  • Post author:
  • Post category:how to
  • Post comments:0 Comments

How To Apply Concrete Sealer With A Pump Sprayer. Deciding on an application tool will depend on the type of concrete sealer you are applying and the amount of square footage you are sealing. Move the finish around with the mop, maintaining a wet edge.

DECO 20 Clear Concrete Sealer 1Gal.
DECO 20 Clear Concrete Sealer 1Gal. from www.decosealers.com

On this technique of the week, jason shows you how to properly seal and backroll a decorative concrete slab! Jason learned that lesson the hard way. When applying the sealer, the layers should be thin, says bart sacco, president of concrete texturing tool and supply in throop, pa.

Push and pull the sealer around, maintaining a wet edge.

The labeling said the sprayer was chemical resistant — a condition that doesn’t mean safe to use with solvent sealers. Normally that would be mineral spirits, but i see on the tech sheet where they say to use lacquer thinner. Following any instructions provided by the manufacturer, you will generally want to spread out the sealer evenly over the concrete using.

Open up the concrete with an etching solution.

Lacquer thinner would be hard on any plastic parts or seals, which is probably why you were told the sprayer only works for a few applications. Remove all oil, grease, stains, dirt, and dust from the concrete. Deciding on an application tool will depend on the type of concrete sealer you are applying and the amount of square footage you are sealing.

On this technique of the week, jason shows you how to properly seal and backroll a decorative concrete slab!

How to apply concrete sealer. Deciding on an application tool will depend on the type of concrete sealer you are applying and the amount of square footage you are sealing. Strip any existing sealer from the surface.

Sprayers to apply concrete, block paving and natural stone sealers we supply a complete range of sprayers to that will spray solvents and water based sealers to create an even finish an all surfaces.

Make sure it can handle solvents and clean it thoroughly with a cleaning solvent so the tip and lines will not clog up for the next use. Our solvent based sprayers are fitted with viton sealers to resist chemical erosion of the sprayer when using solvents. Today we are reviewing the best pump up sprayers to use with most diy concrete sealers.

Jason purchased a pump sprayer at a local home store to apply sealer to a pool deck project.

Three of the most popular brands. Move the finish around with the mop, maintaining a wet edge. If you are going to apply a decorative acrylic sealer or epoxy coat on your concrete floor, using a nap roller in either ¼” or 3/4” size since these are designed to handle rough surfaces.

Leave a Reply